| |
What are Cooler Systems™
by Steere?Sponsor
Advertising Possibilities
Specifications
Accessories
Assembly
What People are Saying
Where Cooler Systems™ Have Been
Contact Us |
 |
The Cooler System consists of 8
interlocking, blow molded panels. |
 (fully assembled) 26½" wide
x 25¼" deep x 61¾" high |
 26½" wide x 25¼" deep |
 (without water cooler) 60 pounds |
 |
The Cooler System is constructed of
rugged High Density Polyethylene with UV inhibitors and is colored Forest Green. |
 |
Cooler Systems will easily
accommodate round or square water coolers up to 10 gallons in capacity. The Universal
Cooler Shelf is designed to hold round or square coolers firmly in place. There is
sufficient room in the compartment to store additional sleeves of cups behind the cooler. |
 |
Cup Holders should be mounted on the inside
of the front panel so the cups extend below the cooler access opening. One or two Cup
Dispensers can be used. Cooler Systems will accommodate 16" high Cup Dispensers
which contain up to 8 ounce cups. |
 |
The optional Trash Bag Frame is
20" wide x 18½" deep x 21½" high (measured to the bottom of the trash
doors) and fits in the Trash Compartment. The frame holds a standard 55 gallon trash bag.
Note: the compartment will hold a standard tournament trash box if the front panel is cut
down below the trash door openings. |
 |
Trash doors can be reversed
indicating recycling on the flip side. If recycling is desired, 2 trash bag frames can be
ordered measuring 10" wide x 18½" deep x 21½" high. These fit side by
side and hold a 30 gallon trash bag. |
 |
Trash: Slide up lower rear
panel and remove.
Cooler: Slide off top panel. Slide up the upper rear panel and remove.
Note: The top panel can be locked in place to prevent tampering or unauthorized access to
the cooler. |
 |
Note: Use indicated measurements for
maximum signage dimensions. |
 |
Sponsor signage attaches to
advertising panels with double face tape, adhesive, or Velcro. Contact us at the number
below if you desire assistance in preparation or procurement of signage. |
 |
Unit will be stable on level
surfaces. For additional stability, holes can be drilled in the recessed openings of the
bottom panel and used with anchoring stakes. |
 |
- 10 gallon cooler
- Trash frames - single for trash only; double for recycling option
- Cup holders - need to be specified to exact cup size used
- Nylon carrying bag for disassembled unit (enables easy transfer to locations on the
course and carefree storage)
- Locking system |
 |
Cooler Systems can be shipped in
three ways:
1. In bulk for quantity orders; e.g. all the front panels will be shipped in the same box
2. The complete disassembled unit in its own nylon bag (if the bag option is ordered)
3. Via UPS (each unit will be shipped in 3 separate boxes) |
 |
Screened opening on the cooler shelf
prevents liquid accumulation. The shelf may also be sprayed with Spectracide® (available
at most hardware stores). |
Steere
Enterprises, Inc. Cooler Systems Home |
